Lynwood W76 Wood Stove with Cast Iron Door, Black Colour Finish
Lynwood W76 Wood Burning Stove with Cast Iron Door, Black Colour Finish
The Sierra Flame Lynwood W76 is a welcome addition for wood burners everywhere, and is what a wood-burning stove should be: efficient, low emissions, and provides great flames with a maximum viewing area.
Versatile, the Lynwood W76 wood-burning stove adapts to any room and will create a cozy atmosphere in any space.
EPA 2020 certified, the Lynwood W76 wood burning stove brings warmth without compromising on air quality.
Mandatory to complete the unit: Reduce Clearance Heat Shield
- 2020 EPA Compliant
- 78% Maximum Efficiency
- 13,784 to 57,674 BTU/hr
- Heats up 2000 ft²
- Maximum Log size – 21″
- Massive glass for fire viewing
|Type||Solid Fuel Room Heater|
|Type of Combustion||Non-catalytic|
|Fuel Type||Dry Cordwood (15% moisture)|
|Main Material||Cast Iron|
|Flue Exit||6” (150 mm) Back to top connector|
|Recommended Heating Area||450 to 2,000 ft.2 (42 to 185 m2)|
|Nominal Firebox Volume||1.55 ft.3 (0.044 m3)|
|Maximum Burn Time 1||14 hours|
|Maximum Heat Output (dry cordwood) 2||57,700 BTU/h (16.91 kW)|
|Overall Heat Output Rate (min. to max.) 2 3||13,784 BTU/h to 57,684 BTU/h
(4.04 kW to 16.91 kW)
|Average Overall Efficiency 3||71% (HHV) 4 76% (LHV) 5|
|Optimum Efficiency 5||78%|
|Average Particulate Emissions Rate 7||1.81 g/h (EPA/CSA B415.1-10)|
|Average CO5||120 g/h|
1 Maximum Burn Time will vary depending on design of home, climate, wood type and operation.
2 Heat Out Range results are determined during specific emissions test established by the EPA.
3 As measured per CSA B415. 1-10 stack loss method. The Maximum Heat Output value is representative of a morefrequent re-fueling cycle than specified.
4 Higher Heating Value of the fuel is obtained per CSA B415. 1-10 test method.
5 Lower Heating Value of the fuel is obtained per CSA B415. 1-10 test method.
6 Optimum overall efficiency at a specific burn rate (LHV).
7This appliance is officially tested and certified by an independent agency. Particulate Emissions rate is obtained using EPA Test Method.
8 Carbon Monoxide Emissions rate results from Test Method CSA B415. 1-10